search

miblooming / JZ-TS24-2

Get it
https://cxdiy.taobao.com/
86 stars 35 forks source link

Wrong Z positioning after end of filament #10

Closed cabped closed 5 years ago

cabped commented 5 years ago

Hello,

I'm having the following issue: when the printing stops after the end of filament detected by the filament end stop connected to JZ-TS35, the position is set do X=0, Y=0 and Z=Z+(some increase, maybe 10?), and the print pause. Then when I refill the filament and unpause the print, the Z axis increases a little beat more, then the X and Y are correctly set to the position where the print stopped, but the Z axis stands bellow the wright position (it is set a little up, but not enough), so the printing resumes over the top of the piece, printing on the air.

miblooming commented 5 years ago

Please upgrade the firmwave: https://github.com/miblooming/JZ-TS24-2/tree/master/JZHelper_ui_editor/JZ-TS35WIFI___(3.5)/firmwave%20lastest