search

miblooming / JZ-TS24-2

Get it
https://cxdiy.taobao.com/
91 stars 37 forks source link

Endstop monitoring triggers BLTouch to deploy probe #19

Closed mziai closed 4 years ago

mziai commented 5 years ago

Hello. I've run into a problem, using JZ-TS40 display from FlyingBear and skr 1.3 mb. It has been configured with the v.2.4.2.2 JZ Ui helper. My BLTouch probe always deploys the probe, even when the printing started, causing crashes. The blue light in it flashes with a period of a second. My experiments using regular display (Reprap full graphics) did'd show this problem. Thus I assume, that the endstop monitoring feature of the display triggers the probing and thus causing the effect. I would appreciate any solution, such as an option to stop endstop monitoring proccess or somehow block the M119 command.

miblooming commented 5 years ago

Please try the new firmware: https://github.com/miblooming/JZ-TS24-2/tree/master/JZHelper_ui_editor/JZ-TS35WIFI___(3.5%264.0)/firmwave%20lastest_landscape

mziai commented 5 years ago

Thank you for your reply. Unfortunately, this version hangs at 100% Update Firmware status. For at least 15 minutes now.

miblooming commented 5 years ago

Delete jzwifi.bin before upgrade. This firmware is not compatible with the custom firmware of FlyingBear on WIFI

mziai commented 5 years ago

Still doesn't work. Tried multiple times and still hangs. Whereas my configured firmware flashes fine.

miblooming commented 5 years ago

Please download the new firmware, and try again. There's a complie error.

mziai commented 5 years ago

I've managed to flash the newer version and now problem is no more. But if I go to the endstop monitor page, it still triggers the bltouch to deploy. Thank you for solving the issue.