Open Sharkys80 opened 4 years ago
Hi
2.Yes there's no German for the 2.8
3.Two method: A) Send gcode by Gcode Common Line, HomePage -> My Tools -> Gcode B)Add buttons to send gcode by UIEditor.
4.Pay me by paypal, and I'll ship the product to you.
Best Regards LoomingXu
------------------ 原始邮件 ------------------ 发件人: "Sharkys80"<notifications@github.com>; 发送时间: 2020年1月14日(星期二) 下午5:11 收件人: "miblooming/JZ-TS24-2"<JZ-TS24-2@noreply.github.com>; 抄送: "Subscribed"<subscribed@noreply.github.com>; 主题: [miblooming/JZ-TS24-2] Problem with Leveling with JZ-TS28 and others question (#28)
Hi
I have a Problem with Leveling with JZ-TS28 , my 3D touch dosnt work with the Display. Without the Display its works fine. After the first Point the Sensor don't deploy. Is the Leveling Option on Display not G28 &G29??
No language support in German for the 2.8 only for 3.5?
Any Code for botton Sends i dont find the correct code in the list i try build Gode M122 and i need the feedback from the TMC ?
And the last question :any other option to buy a 3,5 or 4 display from taobao site?
— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub, or unsubscribe.
It's for JZ-TS35/40, some codes are not enable on jz-ts28
Thank you for the answers. But yesterday a start a test with only printing from SD: So my normal config is UBL is on and setup is complet in Marlin+Simplify3D(start script) + Save UBL mesh values to EEPROM on LPC1768 but when i start.He ignored the the start script wit G28 & G29 J in the gode, the Z axis dosnt compensate its self. printig without Display with only a REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER its work fine .What is the failure?
Can you show me the command lines at beginning of Gcode file?
removed
Maybe there's a compatibility issue with 3D touch. I'll try to fix it. But no that quickly.
OK i can wait thank you, but i will test a Inductive sensor on my second printer. I guess that dosent work too.
So i tested with my 2 printer Melziboard 2.0 and Inductive sensor: You have right, there's a compatibility issue with 3D touch the other Sensor work fine with ABL and display. I hope for fix
Hi
I have a Problem with Leveling with JZ-TS28 , my 3D touch dosnt work with the Display. Without the Display its works fine. After the first Point the Sensor don't deploy. Is the Leveling Option on Display not G28 &G29??
No language support in German for the 2.8 only for 3.5?
Any Code for botton Sends open the serialconsol i dont find the correct code in the list. I try build Gode M122 and i need the feedback from the TMC ?Or where i found the complet list for local instruction (7001 ~ 7999)???
And the last question :any other option to buy a 3,5 or 4 display from taobao site?