Restart MRFC522 fails after hard power down

[Oegtsgeest]

OS version: _W10____

• Arduino IDE version: 1.8.12
• MFRC522 Library version: v1.4.8
• Arduino device: SAMD21 adafruitfeather M0
• MFRC522 device: RFID-RC522

• Tried to save power by switching off and on when required. I used following code:

  if (selectionReceived == 700)   // power down
  {
  pinMode(RST_MRFC_PIN, OUTPUT);
  digitalWrite(RST_MRFC_PIN, LOW);        // hard power down of RFID board 
  }
  if (selectionReceived == 701 )   // power up again
  { 
   digitalWrite(RST_MRFC_PIN, HIGH);                        
   mfrc522.PCD_Init();                    // Init MFRC522 ; Power up  RFIDoard 
  }

  The unit powers down because I see the current dropping by approx 20mA. The restart does not work. Do I use the right code? Or is this a bug? Help is very much appreciated.

[Rotzbua]

idk, but there is already a big thread about power saving techniques #269