Make the cam output full cutout of tip and tail spacer including the 3 straight sides and the shaped end that fits the core, to get the overall core and spacer to a set fixed length. So then the tip and tail spacer is attached to the core first with a small staple or epoxy or tape and becomes say a total of 170cm long, and then fits into 4 corner pockets or tabs in the cassette, like photo album books have on the corners of each photo that they slip into. This would just speed up production a tad and also basically nullify the chances of a mis alignment either by a mis placement during layup or a shift while moving the cassette. On the to do list not urgent just another idea to streamline the process. cheers Rich
Make the cam output full cutout of tip and tail spacer including the 3 straight sides and the shaped end that fits the core, to get the overall core and spacer to a set fixed length. So then the tip and tail spacer is attached to the core first with a small staple or epoxy or tape and becomes say a total of 170cm long, and then fits into 4 corner pockets or tabs in the cassette, like photo album books have on the corners of each photo that they slip into. This would just speed up production a tad and also basically nullify the chances of a mis alignment either by a mis placement during layup or a shift while moving the cassette. On the to do list not urgent just another idea to streamline the process. cheers Rich