Enhancement Request - design bottom mould profiles in SnoCAD and exporting into MonkeyCAM to enable cutting of pressing profiles.
So when we design a board in snoCAD-X it would be great to be able to export the rocker/camber end to end pressing profile into MonkeyCAM. Whether as "one piece" sections or as individual tip and tail and middle sections to allow for shortening/lengthening with interchangeable middle sections to avoid needing to cut multiple profiles for multiple lengths.
This would not just export the profile curve but would "wrap it" adding vertical end lines and horizontal bottom line so its a complete unit ready to cut and glue together as a press profile.
Enhancement Request - design bottom mould profiles in SnoCAD and exporting into MonkeyCAM to enable cutting of pressing profiles.
So when we design a board in snoCAD-X it would be great to be able to export the rocker/camber end to end pressing profile into MonkeyCAM. Whether as "one piece" sections or as individual tip and tail and middle sections to allow for shortening/lengthening with interchangeable middle sections to avoid needing to cut multiple profiles for multiple lengths.
This would not just export the profile curve but would "wrap it" adding vertical end lines and horizontal bottom line so its a complete unit ready to cut and glue together as a press profile.
..... make sense?
@mikemag @danielgraf @bill622