Closed GoogleCodeExporter closed 9 years ago
I'm having this same problem, but with arduino mega 2650
I even don't know what pins I should use. It says 2 and 3 but when I jump them
nothing happens. Please Help us!
Original comment by pedro.ga...@gmail.com
on 22 Aug 2012 at 3:32
Hi, this lib is developed for GSM GPRS Shield of futura/open-electronics.
http://store.open-electronics.org/GSM_GPRS_GPS_SHIELD
I never used IComSat, so I cannot say too much on it.
I can suggest to you to check the doc folder in library's zip and see the
instructions.
Original comment by martines...@gmail.com
on 22 Aug 2012 at 9:47
You need set the jumper (Check the forum reviw) and need a 12v 1amps supply
other than
just the USB. It will work only if The status LED of the SIM 900 is on. I am on
a similar venture . Share idea . My mail id vaishakhkp59@gmail.com
Original comment by vaishakh...@gmail.com
on 8 Sep 2012 at 12:24
You need set the jumper (Check the forum reviw) and need a 12v 1amps supply
other than
just the USB. It will work only if The status LED of the SIM 900 is on. I am on
a similar venture . Share idea . My mail id vaishakhkp59@gmail.com
Original comment by vaishakh...@gmail.com
on 8 Sep 2012 at 12:24
Check this link for library files:
http://iteadstudio.com/store/images/produce/Shield/IComSat/GSM_Shield2.zip
.Share if any further deviation to vaishakhkp59@gmail.com
Original comment by vaishakh...@gmail.com
on 8 Sep 2012 at 12:28
Original comment by martines...@gmail.com
on 11 Dec 2012 at 5:01
This issue section is not longer supported.
Please check the support page www.gsmlib.org
Original comment by martines...@gmail.com
on 6 Jul 2013 at 11:27
Original issue reported on code.google.com by
se...@1108studios.com
on 21 Aug 2012 at 6:30