search

mnemonicdevices / md001

Issue and project tracking for MD-001 Juniper
6 stars 0 forks source link

Increased voltage range #76

Closed cardinal-bin closed 4 months ago

cardinal-bin commented 5 months ago

Describe the solution you'd like If the hardware allows, allow changing to +/- 10v signals.

Describe alternatives you've considered A VCA can be used after Juniper's output to boost the signal.

Potential ramifications or implications This is probably not possible, I assume that the 5v limit is set by the circuitry rather than software. But perhaps I'm wrong! If not though, just delete this suggestion.

ost-ing commented 4 months ago

Unfortunately the hardware is limited to -+5V, so this isn't feasible