mnesarco / MarzWorkbench

FreeCAD Workbench for guitar design
GNU General Public License v3.0
82 stars 19 forks source link

Body Carves #29

Closed Arayl96 closed 6 months ago

Arayl96 commented 8 months ago

I know you mentioned it I believe in one of you videos but I would like to request a way to add top and body carves if it is possible

mnesarco commented 8 months ago

do you mean bevels and belly cuts, or something more complex like a LP top carving?

Arayl96 commented 8 months ago

Both would be good, I know it is really complex and I’m sure complicated so it’s fine if it can’t be done

mnesarco commented 8 months ago

It is not implemented in the current version. But armrest and belly cut are definitively less complex than top carving.

Arayl96 commented 7 months ago

I understand that completely, is there also any way you could add some kind of binding feature in like the parameters for top and back body binding, something where you can create a binding route with the ability to change the height and depth on the route

mnesarco commented 7 months ago

I suppose the binding channel can be done with the OCCT Offset functionality, but it is a bit unpredictable sometimes. I have to check

Arayl96 commented 7 months ago

I think it would be a nice addition to the software, if you find out the best way to do it or if you are thinking of implementing it, feel free to let me know

mnesarco commented 6 months ago

@Arayl96 Body carves (Ergonomic cutaways) are available now (0.1.3)

mnesarco commented 6 months ago

The title of this issue is too ambiguous, it can refer to carved tops or ergonomic cutaways, and also you mention bindings. So as ergonomic cutaways are supported now, i am closing this issue as completed. For carved tops and bindings you can add new issues. Please one specific thing per issue.