The servo gets stuck in LOCKED/DOWN position when the filament is inserted. I can do SERVO_UP as many times as I want, but it will not open. This only happens when filament is inserted. When there is no filament, the servo goes up and down freely.
Troubleshooting steps I took so far:
Connected servo to different board: I connected the servo to my SKR2 instead of the EASY-BRD that came with fystec kit.
The servo gets stuck in LOCKED/DOWN position when the filament is inserted. I can do SERVO_UP as many times as I want, but it will not open. This only happens when filament is inserted. When there is no filament, the servo goes up and down freely.
Troubleshooting steps I took so far: