Closed funkyskull closed 1 year ago
If you have toolhead sensor it will/should avoid this collision. The ONLY time it happens with TS is on initial calibration of bowden length. You can manually edit this in ercf_vars.cfg (or just hold the ECAS whilst calibrating T0).
That said, many have wedged in the ECAS with some tape or dab of glue.
I'm running into an issue homing to the extruder. I think it's related to the 'spring-back' collision detection process putting too much force on the selector/encoder which pops the entire ECAS out.
Since I have a toolhead sensor can I disable the homing to extruder portion? Looking at the code it seems accounted for but not possible due to a configuration issue?