Open danyial opened 4 months ago
What sensor do you use on toolhead sensor? I'm using filametrix with microswitch and ball and sometimes filament debris jams the sensor.
This looks like your toolhead sensor is getting stuck...
Viewing the log you can see that the filament is "reversed homed to extruder sensor". That means it is retracted until the extruder (entrance) sensor no long sees the filament.
The safety check then spots that the toolhead sensor (inside the extruder) is still triggered and hence the pause -- there is no point in ignoring this because it will cause issues later.
Do you use the microswitch toolhead sensor? (Hall Effect switches are a disaster in my experience). Also is the cut piece of filament somehow being pulled from the nozzle and blocking the toolhead sensor?
I don't know why, but sometimes the unload fails and I'm sure the synced unload not works if it fails. It tries to unload to the buffer but the filament is still inside the extruder (toolhead sensor is triggered)
Here is my config: