Hi, I'm having some issues putting together a layer layout for an upcoming Phantom build case. I was planning in having a ANSI 150 plate cut instead of buying one (probably cut from 1,5mm aluminum, like the ones on MK) and can't figure out, from the information on the README, the logic behind selecting the correct layers.
Also, is there any Phantom ANSI 150 plate design that is known to work with this case (and that you could share any drawings)?
Also, if my aluminum cutter guy is not able to work out the plate job and I end up with only the MK plates options, is it going to be the same way to go?
Hi, I'm having some issues putting together a layer layout for an upcoming Phantom build case. I was planning in having a ANSI 150 plate cut instead of buying one (probably cut from 1,5mm aluminum, like the ones on MK) and can't figure out, from the information on the README, the logic behind selecting the correct layers.
Also, is there any Phantom ANSI 150 plate design that is known to work with this case (and that you could share any drawings)?
Thank you, Eduardo.