search

mposchl / arducam-osd

Automatically exported from code.google.com/p/arducam-osd
0 stars 0 forks source link

OSD doesnt fit on the screen #62

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
What steps will reproduce the problem?
1.Connected to APM1 and Arducam OSD tool
2.Foxtech M800 8" monitor, Jdrones miniOSD
3.Same result connected via FTDI cable or via APM connection

What is the expected output? What do you see instead?
I expect the whole display fits the screen. The bottom three grid lines don't 
show and top grid line is half off the screen. Width is displaying ok

What version of the product are you using? On what operating system?
v2.0 on Win7

Please provide any additional information below.
I tried to adjust the screen up and down and ratio, but i still don't get the 
full display showing.

Original issue reported on code.google.com by jrcam...@gmail.com on 1 May 2013 at 4:26

GoogleCodeExporter commented 9 years ago 
Your camera resolution is too small, you need a higher resolution camera. This 
system I believe is optimised for 576p not 480p. Please try searching for forum 
threads on this problem, I'm sure you will find the answer this way.
Hope this helps.

Original comment by doozer.s...@gmail.com on 12 May 2013 at 11:55