[Startup] Test Report

[mregueira]

• Check for SC on power lines
• Solder Linear regulators and Power connector
• Check again for SC on power lines (result: 1K aprox. impedances)
• Connect power with ampmeter (result: power rails OK, idle current 140mA)

[mregueira]

• DSP - Basic has the configuration that works OK, i was mistaken some things on the SigmaStudio configurer
• I shuted down the DSP peripherals that were not in use, so i can save power and no overheat the linear regulators
• Tested on sampling 48KHz and 192KHz, no hardware issues, signal is perfectly clean even in 8KHz/16KHz (at 16KHz it dances as always, still don't figured out that but is a problem of the incoming signal, not the project)
• Configured a couple of registers on external ADCs and DAC