Closed 19Forty closed 11 months ago
I'm an idiot and did half of my testing with a lose hot end. Joined Patreon as penance (and Thanks)
This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.
Did you test with a precompiled firmware?
Yes, and the problem still exists.
Bug Description
When using the probe to level the bed, the it prints too high in the front right.
The Right side of my Bed Prints too High and left a fraction too low.
Nozzle is closest to the Bed at the back left and furthest at the front right.
Sorry if this is my mistake and not a Bug.
Bug Timeline
First had the Issue in September, gave up and went back to stock. Trying again now - same issue.
Expected behavior
I expect that using the Tramming wizard and UBL/ABL would result in a consistent first layer. Like it does using Stock Firmware.
Actual behavior
It always prints too high at the front right.
Steps to Reproduce
In September I tried
I followed the suggested instructions to manually level my Bed and had much better results, however I was perplexed as Auto levelling worked previously on stock firmware.
I then flashed back to stock and leveling worked fine.
I flashed back again this weekend (Precompiled Ender3V2-422-BLTUBL-TJC-MPC-20230904) after replacing my extruder with a Sprite NEO SE and replacing my build plate with a better PEI sheet. Whilst the issue is less pronounced (I could print smaller things fine) it is still there.
To test I did the following: For these tests I used Teaching Techs First Layer Calibration tool and Printed from the SD Card.
I then flashed to stock again to confirm and printed a first layer test - all good.
I then compiled a Version of the Firmware with UBL unticked in the configurator and tried using that, in case it was specifically a UBL issue. Ender3V2-422-BLT-TJC-MPC-20230904
It still is not level.
Version of Professional Firmware
Ender3V2-422-BLTUBL-TJC-MPC-20230904
Printer model
Creality Ender 3 V2 Neo
Electronics
Board 4.2.2 / Chip RET / Display TJC
Add-ons
New PEI Build Plate (Tried with Original too), Sprite SE Extruder (issue was there with original too)
Bed Leveling
UBL Bilinear mesh
Your Slicer
Cura
Host Software
None
Additional information & file uploads
No response