mriscoc
commented
4 months ago Hi, this is not a general printer support forum. Many problems can be easily solved by reading the firmware Wiki please check the calibration guide.
This Issue Queue is for firmware bug reports and development-related issues, and we prefer not to handle user-support questions here. For best results getting help with configuration and troubleshooting, please use the following resources:
Enhanced support in Patreon: https://www.patreon.com/mriscoc
Free community support:
- Github discussions: https://github.com/mriscoc/Ender3V2S1/discussions
- Facebook: https://www.facebook.com/groups/professionalfirmware
- Telegram: https://t.me/ender3v2s1firmware
- Reddit: https://www.reddit.com/r/Ender3v2Firmware
- Discord: https://discord.gg/3dprinters
Did you test with a precompiled firmware?
Yes, and the problem still exists.
Bug Description
The Automatic Tramming Wizard is only probing the most extreme points (almost off the plate) which is causing issues with my glass bed.
Bug Timeline
No response
Expected behavior
Probing points closer to above the adjustment knobs
Actual behavior
Probing points close to x0 y0, x0, y248, ect.
Steps to Reproduce
No response
Version of Professional Firmware
20240122
Printer model
Ender 3 V2
Electronics
4.2.2
LCD/Controller
No response
Other add-ons
No response
Bed Leveling
UBL Bilinear mesh
Your Slicer
Other (explain below)
Host Software
None
Additional information & file uploads
Using CRTouch