Proper way to refresh after wyze Cam name change?

[Roachforlife]

Describe the bug

Wondering how to refresh the cameras properly when I rename them in wyze? Specifically I had to replace one called CamA lets say, so CamA changed to something else and the new Cam now has the name CamA. It sees it but never shows the proper connection or loads the feed. Look to reset the back end connection to update it. I did this once before and ended up uninstalling and reinstalling in HA. Figured there might be a better way to do this.

Also on a different topic but possible to get motion detection sensor within HA for the cams? I didn't see it but figured I'd ask. Thanks

Environment (if applicable)

• Affected Camera(s): wyze v3
• Affected Camera Firmware:
• Affected Bridge Version: latest
• Bridge type:
  • [ ] Home Assistant

[mrlt8]

I believe you should be able to pull fresh camera data from the web ui by using reset -> clear cache and reconnect

[Roachforlife]

I did that, (it says restart ok) but still does not play. Still seeing a feed from a week ago even when i go to Controls > Stream > Enable or Controls > Stream > Start

[Roachforlife]

After some time I get the following