Add functionality for pressure controller input

[JustinLangridge]

Pressure controller needs adding to ini file (we can do this). However, code need to allow controller set point to be input into UI in millibar

[lo-co]

This is not an issue. It is already there. Have you tried adding it? It will be another entry in the Alicat section of the INI file.

[JustinLangridge]

Thanks for adding this in the ini Matt. It is now showing up on the flow control tab and we can control the setpoint. However we're not reading back pressures

[lo-co]

Didn't do anything with this - you did. I will look into what is going on with the returns.

[JustinLangridge]

That’s funny - must have been Dave at the end of last week. Might not be related, but could this be a factor with the data file writing issues that have appeared this week?

From: MSR [mailto:notifications@github.com] Sent: 03 August 2016 21:44 To: lo-co/exscalabar_server exscalabar_server@noreply.github.com Cc: Langridge, Justin justin.langridge@metoffice.gov.uk; Author author@noreply.github.com Subject: Re: [lo-co/exscalabar_server] Add functionality for pressure controller input (#148)

Didn't do anything with this - you did. I will look into what is going on with the returns.

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHubhttps://github.com/lo-co/exscalabar_server/issues/148#issuecomment-237367128, or mute the threadhttps://github.com/notifications/unsubscribe-auth/AMmoAk8avUl5laQ1_51SUmlTREVqVQ4Pks5qcP2agaJpZM4JWi5U.

[lo-co]

No, I mean - all you had to do was add it to the configuration file... I may have fixed the Q0 stuff. I will fix the pressure units.

[lo-co]

I am taking no action on this as I assume that all is well with this...