I’m very surprised that it is so unknown, because it is a very usefull and powerfull software, and there’s no other similar software open-source like this.
I begin to use it some weeks ago, and I’ve found some small bugs on the screen ‘’Cut” :
if we check “On the right side”, the associated textbox is not enabled.
on the 3D view, the airfoils are inverted for left wing.
during an cutting operation, if we click “Cancel”, the process is stoped. But, after that, it is impossible to restart a cutting process. If we go to “Guillotin & Move”, it is also impossible to disconnect or reset GRBL, and doing manual move.
if we select “Cut only a spar/slot”, the button “Save GCode” still saves the wing gcode, not the spar or slot gcode as it should do.
One suggestion : when cutting, it should be nice to show graphically the current wire positon (by drawing a red line ?)
Hello,
Many thanks for this very great work !
I’m very surprised that it is so unknown, because it is a very usefull and powerfull software, and there’s no other similar software open-source like this.
I begin to use it some weeks ago, and I’ve found some small bugs on the screen ‘’Cut” :
One suggestion : when cutting, it should be nice to show graphically the current wire positon (by drawing a red line ?)
Best regards from France ;-)