search

mvalla / openhab-addons

Add-ons for openHAB
Eclipse Public License 2.0
24 stars 16 forks source link

thermo: setmode in MANUAL does not work #80

Open Gozilla01 opened 5 years ago

Gozilla01 commented 5 years ago

In the value field on the channel setmode, the MANUAL does not work.

mvalla commented 4 years ago

more information needed, at least:

etavideo commented 4 years ago

Hi Massimo, with the latest version (2.5.0.M3) the manual mode bug has re-emerged. I have a temperature control unit 3550, 15 zones of which 13 with standard probe probe with knob and 2 zones with probe for convector fan management (which works, but the status of fan coil is not received). On all areas I have the problem (which was also reproduced by Stefan and Godzilla) of the manual that is set only when I change the temperature. In practice, if I switch from any mode (OFF, Protection, Auto) to Manual mode, the control unit remains set to the previous mode. The only way to actually change the way Manual is to put it in manual and then change the temperature. In fact, only if I change the temperature after putting the manual mode, it starts working correctly. If instead I only set the Manual mode, the software writes Manual, but the operating mode remains the previous one until the temperature is increased or decreased by one degree. Try checking, I'm sure there is this problem that had been fixed in the previous release. If you need more information, write to me. Thanks!