search

mvrdevelopment / spec

DIN SPEC 15800 General Device Type Format (GDTF) and My Virtual Rig (MVR) File Format description DIN SPEC 15801
64 stars 13 forks source link

Define physical unit for Attribute "Frost" #34

Open danielmuellerma opened 5 years ago

danielmuellerma commented 4 years ago

@petrvanekrobe I talked to Honza and he said that the physical unit of Frost should be "Degree". Is this correct?

petrvanekrobe commented 4 years ago

It could be view that way as it "opens up the beam" a bit, but not only on the edges.

I think what he meant was this: we specify frosts as (typically): 2°, 5°, 20° In many units, we do not even specify what frost we use, instead, but we sometimes mention: "frost goes from 60° to 75°", typically in wash units.

So if we say in physical properties "Degree", then we go from 0 to 5°, what will do visualizer do? Because it must be "beam ° + frost °", so that is what probably should happen. + fuzzy edge should be applied, not only on the beam edge but also on gobo edge...