n-e-y-s / G27_Pedals_and_Shifter

Arduino USB interface for Logitech G27 Pedals and Shifter
67 stars 16 forks source link

Low Frame Rate when Calibration isn't running. #1

Open KillerXtreme- opened 4 years ago

KillerXtreme- commented 4 years ago

So I've gone through the steps to install this on a clone arduino micro clone that does use a 32u4. I've set it up only for my pedals as I see no need to also include my shifter since I'm still using the g27 wheel and gain no benefit from it. Anyways, it seems if I'm not running the calibration program the update rate of the pedals seems to be horrid something like 1-2/sec with still a 10-bit resolution. However if I run the calibration program in the background I get the full framerate and responsiveness at a 10bit resolution. I see no information reguarding this. How can I just plug it in and have it be recognized as just a controller?

n-e-y-s commented 4 years ago

Sry for late response, I must have missed this in my inbox.

Did you try also with the shifter just for reference if this issue is present on your setup also with the shifter included in the arduino?

n-e-y-s commented 4 years ago

I can't reproduce with my setup. What I do see on windows, is the low framerate problem after closing the calibration program. However, after unplugging and replugging the USB connector of the arduino, the framerate is back to normal (without running the calibration tool in the background).