Hello, i've been using your code and so far so good except that i think my axis (the white dot on the gui software) is getting disconfigured. When i first started it was on the middle, but after a while using the shifter (i only have the shifter and i'm using it with a g29 wheel) the axis went a little to the left and thus making my gears overwrite each other, i made the last and best possible configuration, leaving only a little void area between neutral and all the other gears. My question is: it's possible to calibrate only the axis instead of the gears zones ? Because i'm afraid that if get's disconfigured again i'll be unable to calibrate it.
I'll keep using it and if it happens i'll post here again
Hello, i've been using your code and so far so good except that i think my axis (the white dot on the gui software) is getting disconfigured. When i first started it was on the middle, but after a while using the shifter (i only have the shifter and i'm using it with a g29 wheel) the axis went a little to the left and thus making my gears overwrite each other, i made the last and best possible configuration, leaving only a little void area between neutral and all the other gears. My question is: it's possible to calibrate only the axis instead of the gears zones ? Because i'm afraid that if get's disconfigured again i'll be unable to calibrate it.
I'll keep using it and if it happens i'll post here again
Here is the pic: