Using the "All connected" expand selection option doesn't work quite right.
For instance if I draw a tube diode on the left and a triode on the right, then
connect their plates with a schematic resistor, then select the triode and
"expand all connected", it will select the triode and the resistor, but not the
tube diode, even though they are all connected (it works if I use two triodes
however).
Incidentally, almost all tube diodes are intended for rectifier use and have
two plate/cathode pairs. Unlike triodes where it is usual to show the halves of
dual triodes separately, it is the common practice to show both diodes of the
rectifier tube, or at least both plates if there is a common cathode. Here are
the common depictions of these variants:
http://www.co-bw.com/Images_Audio/Vacuum_Tube_Types_circ326.gif
Original issue reported on code.google.com by pmfawc...@gmail.com on 21 Aug 2013 at 6:36
Original issue reported on code.google.com by
pmfawc...@gmail.comon 21 Aug 2013 at 6:36