search

namoamitof / heekscad

Automatically exported from code.google.com/p/heekscad
Other
0 stars 0 forks source link

Heekscnc generation toolpath issue. #361

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
What steps will reproduce the problem?
1. Create circle shape with diameter > 20mm
2. Convert circle to sketch
3. Select created sketch and 3 mm Carbide Slot Cutter
4. Add new milling operation: profile operation
5. For selected profile select tool on side: inside or right.
6. Select Go to generate toolpath
7. Verify toolpath - green line

What is the expected output? What do you see instead?
The generated toolpath radius shall has the same center point as created 
circle. And radious of the toolpaht shall be about 1.5mm smaller than milled 
circle. Start and End points shall be inside the circle.

In my example Heekscnc has generated toolpath which has different center point 
or it isn't circular. See attached image.

What version of the product are you using? On what operating system?

Windows: XP  Polish language version
Heelscnc: HeeksCNC 0.18.0

Please provide any additional information below.

I think some meaning may be Windows language version, because I also installed 
Heekscnc in the same version on different Windows with English language 
version. On the second (English) installation generation toolpath on the same 
example seems to be OK.

Original issue reported on code.google.com by kus.pi...@gmail.com on 26 Aug 2011 at 6:23

Attachments:

GoogleCodeExporter commented 9 years ago 
this is whear 
what system are you on and what post processor are you using 

this is never seen bevor all works right  in version 0.18

Original comment by lot...@foengarage.de on 26 Feb 2012 at 8:43