I noticed that when I create a new tool, such as an end mill or a ball end
mill, the flat_radius and/or corner_radius entries aren't filled out
automatically. When I change the type of tool from an end mill to a drill bit
and back again, the entries do get populated.
I'm looking at this because of a lot of experimenting with libactp.
Thanks,
Dan Falck
Original issue reported on code.google.com by ddfalck2...@yahoo.com on 1 Sep 2010 at 3:54
Original issue reported on code.google.com by
ddfalck2...@yahoo.com
on 1 Sep 2010 at 3:54