Touch Automation not working with single Faderport V2

navelpluisje / reasonus-install

Control REAPER with your FaderPort v2, 8 or 16 as it was intended

https://navelpluisje.github.io/reasonus-faderport/

MIT License

10 stars 1 forks source link

Touch Automation not working with single Faderport V2 #21

Open phenty opened 2 years ago

phenty commented 2 years ago

I've installed V1.0.1 on Windows 10 64-bit. I'm using the single Faderport V2 and everything looks great except the touch automation only works when the fader is moving. When I stop moving the fader (but still touching it) it jumps back to the current automation levels and starts following what's already there. I apparently have the latest firmware (v3.51). Anything else I can check?

navelpluisje commented 2 years ago

Hi Phenty, this is a known issue. I'm not quite sure why this happens. It's a v2 issue only. The faderPort 8 and 16 are working fine.

I currently working on v2 (takes longer then I hoped). I hope that that will fix it because it will be using the latest CSI version