search

nevermore3d / Nevermore_Mini

WORK IN PROGRESS: Nevermore Mini Air Filter
49 stars 3 forks source link

Base_and_Cartridges.stl empty layers in OrcaSlicer #2

Open MallocArray opened 1 month ago

MallocArray commented 1 month ago

When opening Base_and_Cartridges.stl from the Complete_Basic_Build folder in OrcaSlicer 2.0.0, an error is reported when slicing. "One object has empty initial layer and can't be printed. Please Cut the bottom or enable supports"

Individually the files seem fine in the Parts_and_Mods folder. And perhaps it is just something in my slicer config, but wanted to report it.

image

0ndsk4 commented 1 month ago

It’s likely the built in supports of the cartridges. There’s a 0.2mm gap (that’s why 0.2mm bottom layer and 0.2mm layer height is important for easy support release) between support and cartridge, that the slicer “correctly” identifies as a potential issue - however, its intentional, it’s supposed to be an empty layer there :)

MallocArray commented 1 month ago

Ok, this was mostly my fault. I only see the cartridges in the Base_and_Cartridges.stl file, but to start with I was only going to do the base, so I used the Split>To Objects function so I could print individual parts and that is what results in this error. If I slice the whole file as it is, then it is successful.

That being said, I don't see individual files for the Cartridges or the mini_beam object from Fusion, so this combo file is the only STL/3MF file available currently.

Could/should these be made as standalone files as well?