search

nevermore3d / Nevermore_Mini

WORK IN PROGRESS: Nevermore Mini Air Filter
55 stars 3 forks source link

missing fastner? #4

Open NateBatchelder opened 1 month ago

NateBatchelder commented 1 month ago

is there a fastener designated for the carbon filter latch ? I don't see anything in the BoM.

It could be a press fit pin, or maybe a m2 screw if there was a recess for a SHCS in the corresponding carbon filter body .

0ndsk4 commented 1 month ago

Hi,

Sorry for the bad instructions. The latch hole is for regular 1.75mm filament. Measure the needed length with just the cartridge to be sure you insert enough filament once the latch in place. It helps to make the filament end a bit pointy. Push+"wiggle-rotate" it in place using pliers, then cut off the surplus with an xacto blade so it's level with the cartridge (if not the cartridge will be pushed out slightly, which can cause sealing and interference issues).