Open prnthp opened 2 years ago
Not actually an issue. This is a wonderful design! Thank you!
I just wanted to add that the vacant LED_F port on the Chitu M20 board for the Mars 3 supplies 24 V while the printer is on.
LED_F
I decided to route the wire externally through a gasket I printed so it is easier to move around and remove.
That is fantastic! Thank you!
eduncan911
commented
2 years ago eduncan911
commented
2 years ago
Not actually an issue. This is a wonderful design! Thank you!
I just wanted to add that the vacant
LED_Fport on the Chitu M20 board for the Mars 3 supplies 24 V while the printer is on.I decided to route the wire externally through a gasket I printed so it is easier to move around and remove.