M2 POE Gateway open telnet fail

[miniknife88]

follow telnet readme,the LED does not turn purple

[niceboygithub]

Format USB thumb with FAT32 in Windows.

[miniknife88]

FAT32 format is ready，but the LED does not turn purple

[niceboygithub]

Single partition format to FAT32.

The gateway must be power off before hold the button.

[wu-cl]

I have the same problem. Use fat32 single partition usb device，power off before hold the button. After re-Plug-in, the yellow light goes out and starts flashing blue, no purple.

[wu-cl]

Use MBR NOT GUID !! It WORKS!

[Sircoco2]

the yellow light goes out and starts flashing blue, no purple.

[niceboygithub]

the yellow light goes out and starts flashing blue, no purple.

Please check the format of your USB Disk. (MBR, single partition with FAT32)

[lihuohuo9527]

There will still be a TELNET password Devices in aqara getaway cannot be used after M2 2022 (POE) restarts

[lihuohuo9527]

1. There is still a telnet password, but aqara getaway is working properly

2. After restarting the m2 Poe, the devices in the aqara getaway cannot be used

[yebjx]

telnet m2-2022-poe ，The username is admin, and the password is left blank, and the password is incorrect

[vachenli]

my usb disk is mbr signle partition with FAT32,and the m2 2022 light is change to purple,but , i cant telenet after it restart

[Chengxuyuan0]

telnet m2-2022-poe，用户名为admin，密码留空，密码不正确 I tried to connect to the M2-2022-POE device using Telnet with the username 'admin' and left the password field blank, but the password was not accepted. I encountered the same issue.