I use both Aqara Home app and HA (HAOS on ESXi host). I have a TH sensor connected to a M1S gateway before, and later I set up a new P3 gateway, and as per required by the Aqara Home app, it asked me to connect the TH sensor to the P3. I did so and in the Aqara Home app, I can see it is correctly migrated to the new gateway (P3) and everything works fine. However, in HA, I can see this device is under both gateway, and in the device page, it shows two gateways in the device info box (see attached screenshot). I wonder how can I remove the link to the previous gateway and keep it only shown in the new gateway? I tried to reconfigure both gateways in HA (without deleting and adding again), it doesn't work. Restarting HAOS various times also does not work.
BTW, if I go to the M1s' device info page, the TH sensor does not show in the connected device.
It's OK for me to manually edit some yaml file (if needed), but I don't know where to find these files.
I use both Aqara Home app and HA (HAOS on ESXi host). I have a TH sensor connected to a M1S gateway before, and later I set up a new P3 gateway, and as per required by the Aqara Home app, it asked me to connect the TH sensor to the P3. I did so and in the Aqara Home app, I can see it is correctly migrated to the new gateway (P3) and everything works fine. However, in HA, I can see this device is under both gateway, and in the device page, it shows two gateways in the device info box (see attached screenshot). I wonder how can I remove the link to the previous gateway and keep it only shown in the new gateway? I tried to reconfigure both gateways in HA (without deleting and adding again), it doesn't work. Restarting HAOS various times also does not work.
BTW, if I go to the M1s' device info page, the TH sensor does not show in the connected device.
It's OK for me to manually edit some yaml file (if needed), but I don't know where to find these files.