Can't align wire under board

[GoogleCodeExporter]

What steps will reproduce the problem?

1. Add a blank board
2. Add some wire
3. Try to align the wire to under board by choosing "Send backward"

Wire doesn't go under board as it should. It would be good for making 
underboard wires because then I would just decrease the alpha of the board and 
it would be seen. Decreasing alpha value of the wire wouldn't have the same 
effect.

Original issue reported on code.google.com by asdfghq...@gmail.com on 5 Jul 2013 at 8:41

[GoogleCodeExporter]

wires cannot go under boards at the moment, they are in a separate layer that's 
always above.

Original comment by bancika@gmail.com on 5 Jul 2013 at 8:42