search

nikshriv / cync_lights

Home Assistant Integration for controlling Cync switches, plugs, and bulbs
164 stars 57 forks source link

Switches toggle on and off in quick sequence #98

Open xa3831 opened 5 months ago

xa3831 commented 5 months ago

I just added the cync integration to home assistant. I have cync paddle switches and dimmers. They all have the same problem. When I switch ON in HA it does light up but after a few seconds the switch goes OFF in HA. The light stays ON. If I switch it ON in HA and quickly switch it OFF in HA (before HA automatically changes to switch to OFF), then the physical switch goes ON/OFF/ON/OFF... for a few seconds. This does not occur every time but still very often.

jkjunk42 commented 5 months ago

Integration has been down about a week.

c-robo commented 4 months ago

Seeing the same behavior as described by OP. Have re-configured the plugin several times and removed/readded devices.

Shad0wguy commented 4 months ago

Seeing similar issue with my cync bulbs. I can toggle them on but they will not turn off from HA and the status shows them as off.

schilling3003 commented 4 months ago

Seeing similar issue with my cync bulbs. I can toggle them on but they will not turn off from HA and the status shows them as off.

I just started experiencing this as well. I can turn the bulbs on via HA, but not off. Everything works fine in CYNC app.

Nessipud commented 4 months ago

Seeing the same thing here.

mshaub commented 4 months ago

I am getting a mix of that behavior (only when triggered from HA) but more frustrating for my use case, I have a Cync Toggle Switch that controls 1 hardwired light and its state should trigger multiple other lights to turn on/off in sync. But, HA isn’t reporting the state of the switch so my other lights won’t follow for now. The official Cync app is working, so I know it’s this integration that’s the issue. Hope it can be resolved soon, or I can flash new firmware to my switch.

TenderBabyMeat commented 3 months ago

Having this same issue as well. Cync app is fine, integration not so much, etc. Refreshing the integration hasn't helped.

kariudo commented 3 months ago

This integration definitely seems "broken" right now.

I don't get status updates on state change in HA. I see the flickering mentioned above. Though I seem to be able to turn the light on with light.turn_on and off with .turn_off, toggling makes a mess and state failure makes automations...hard.

jamesdlyn commented 2 months ago

I was noticing erratic behaviour the past little while. Try enabling logging and see if you get the same error as reported in #96. Should be resolved from commits on May 20, 2024. Now my entities report status and have not noticed any erratic behaviour (yet).