search

nk25719 / PMD___aka-KiCad-esp32-6leds-2switches-1pj-circuit-

In this repo I am practicing KICAD. Created an ESP32 DevKit V1 module and a PCB footprint. I designed a circuit around this ESP32 consisting of six lamps, four switches, and two power jacks and added a voltage regulater to Vin to maintain a supply of +5V. (This project was originally made of two switches and 1 power jack and was named homeWork2.)
0 stars 2 forks source link

EnclosureREVa (The holes are mirrored.) #58

Closed samoyin closed 1 month ago

samoyin commented 1 month ago

Describe the Failure / Bug A clear and concise description of what the failure / bug is.

Short Summary of the expected behavior: The expected behavior is that the top should fit over the printed circuit assembly and the LEDs should come through the holes. Short Summary of the buggy behavior: The LEDs and other parts don't line up.

MIRRORED ISSUE

The enclosure design appears to be mirrored.

Device Under Test, aka DUT Steps to reproduce the behavior:

  1. Model Number: Homework 2 printed circuit assembly of 2024. board marked as 20240421 on silkscreen.
samoyin commented 1 month ago

Make a REVb file and make the following changes; 1.) Move the location of the transistor and LED beside barrel jack. 2.) The entire top is mirrored change x to -x on the OpenScad code.

samoyin commented 1 month ago

The issue has been solved by moving the holes of the enclosure to the negative x direction. image This is the new enclosure. The LEDs all fit inside and the holes in the correct location.