H1 H3 cannot match the corresponding pads on the PCB board

nliaudat / esp32_8ch_motor_shield

An ESP32 based 8 channels motor controller (to replace Homematic IP Floor Heating Actuator)

Other

90 stars 17 forks source link

H1 H3 cannot match the corresponding pads on the PCB board #11

Closed flexmatics closed 2 years ago

flexmatics commented 2 years ago

Hey,

Ordered PCB using the files here: https://github.com/nliaudat/esp32_8ch_motor_shield/releases/tag/v54

JCB gave this reply:

Deselected these parts as didn't know what to do - did I mess up or can still expect to get working board? Corrected PDF from JCB should look like this:

Thanks.

nliaudat commented 2 years ago

Hi, H1 and H3 are only mounting holes. You can delete them safely. I've ordered many time that PCB and they never complain ... H1 and H3 have enough space in easyeda. Regards

flexmatics commented 2 years ago

Clear, thank you. Probably somewhat depends on the guy who picked up the assembly.