search

nliaudat / esp32_8ch_motor_shield

An ESP32 based 8 channels motor controller (to replace Homematic IP Floor Heating Actuator)
Other
90 stars 17 forks source link

[BUG] - short circuit at BMEF in Bord: v57 rev 1.48 #55

Closed DerMo92 closed 7 months ago

DerMo92 commented 7 months ago

Operating environment/Installation (Hass.io/Docker/pip/etc.):

ESP (ESP32/ESP8266, Board/Sonoff):

ESPHome version (latest production, beta, dev branch)

Affected component:

Description of problem:

Bord: v57 rev 1.48 At latest version of this Board with RJ10. I wanted to use this version since I'm using the original Motors with RJ10 Plug. while using it the BMEF ( Mesures of the Channels to see if end stops are reached) I always got 0,008V. That is basically short circuit. After a long investigation with a friend we found out, that all four channels have a short circuit to ground at the pin holes though the board. Compared to the latest version they are not isolated at the bottom layer to the Ground Polygone. (check images below) I suggest a warning in the Documentation for now and at best a correction in the Gerberfile. For me it was too late - we repaired it manually - for anyone who has the same issue check below.

image

image

Problem-relevant YAML-configuration entries:

PASTE YAML FILE HERE

Logs (if applicable):

PASTE DEBUG LOG HERE

Additional information and things you've tried:

nliaudat commented 7 months ago

Many thanks for showing that issue. I've corrected the release https://github.com/nliaudat/esp32_8ch_motor_shield/releases/tag/v57

It's too late, but I recommend you to use only the latest versions, even if the connectors no longer use RJ11. Just cut your cables and follow https://github.com/nliaudat/esp32_8ch_motor_shield/blob/main/VDMOT_wiring.md.

Thanks again for this bug report.