nlrb
commented
4 years ago Hi Paul,
The app only support controlling the Visonic via serial communication, not via a Powerlink. It sort of replaces the functionality of the Powerlink and saves you the cost of adding that part. You also cannot use the Powerlink together with controlling it via RS232/Homey app (there can only be one 'master' on that port).
Best regards, -Ramón.
Hi,
I have a Powerlink2 Internet module installed in the Visonic2 PowerMaxPro. I can interact with the Visionic Webservice via the browser on the standard HTTP-port. But I like to control the Visonic also via the Homey app and downloaded your app.
Is there a way to connect your Visonic Homey app directly to the Powerlink2 module so it can read all the required information? At this moment I can't bypass the first step, Add Paneldevice with the correct IP-address and port combination.
I saw you're using the telnet port during the initial panel setup so I was wondering if i could access on this port my Visonic PowerMaxPro. I tested this from the command-window and can connect to the Visonic PowerMaxPro via the telnet command. I got a login and after that the password, However I don't know what the default username and password is to access the PowerMaxPro via telnet.
The first step in my fault domain isolation is the following: Does you app support adding the PowerMaxPro via a Powerlink2 module? I hope so because then I don't need to buy a Dual RS232 Interface module , if still possible, and RS232-Ethernet converter. And if it is possible what are the IP-address/Port combination, telnet port, and more important the username/password combination you use.
I hope you can help. It seems that you made a nice Visonic app.
Best Regards