search

nobletoll / powersdr-if-stage

Automatically exported from code.google.com/p/powersdr-if-stage
Other
0 stars 0 forks source link

Automatic calibration of signal levels between K3 S-Meter and PowerSDR/IF Stage #135

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
We can use the S-Meter value reported from the K3 to calibrate the relative
signal levels in PowerSDR/IF Stage.  Need more thought here on how this
will work.

Original issue reported on code.google.com by mccleme...@gmail.com on 17 Feb 2010 at 5:32

GoogleCodeExporter commented 9 years ago 
I was thinking it might be easier to ignore the Preamp settings (or do this 
when it
is set to "Off"), and just apply the correction underneath.  It may be harder to
match up to specific Preamp settings and actually automatically change the 
Preamp
control value.

Original comment by cgates...@gmail.com on 17 Feb 2010 at 5:56

GoogleCodeExporter commented 9 years ago 
[deleted comment]
GoogleCodeExporter commented 9 years ago 
[deleted comment]
GoogleCodeExporter commented 9 years ago 
My initial thought was to clear out all the entries from the preamp box when we 
were
doing this. Maybe place one entry in there that says "automatic".

Original comment by mccleme...@gmail.com on 17 Feb 2010 at 6:03

GoogleCodeExporter commented 9 years ago 
Yeah.  We could add an "Auto" to it.  The functionality would only work if 
"Auto" is
selected, and the others will behave as before.

Of course, "Auto" would be selected by default when connected to a K3.  "Auto" 
should
not exist if connected to any other rig.

Original comment by cgates...@gmail.com on 17 Feb 2010 at 6:06