search

nobletoll / powersdr-if-stage

Automatically exported from code.google.com/p/powersdr-if-stage
Other
0 stars 0 forks source link

In the modes DIGL and DIGU the freq. goes to 54MHz / 500kHz #227

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
What steps will reproduce the problem?
1.Connect to K3
2.Go to any freq. any mode, except DIGL / DIGU
3.Switch mode to DIGL or DIGU

The frequency of the K3 goes to the upper freq. limit 54MHz and toggles 
every few seconds between the lower freq. limit (500kHz) to te upper limit 
(54MHz). It stops when any other mode is selected.

What version of the product are you using? On what operating system?
PowerSDR/IF v. 1.19.3.5 - Windows XP SP3 on Laptop SL500, Thinkpad / Dual core 
processor - 4 GB RAM - K3 transceiver - LP Bridge 1.0.8 The K3 is connected 
directly to the LP Bridge via an USB / RS232 converter cable to the K3 COM port.

Please provide any additional information below.

This only happens when the K3 is connected (START lights up blue)
It also happens when I switch mode on the K3 to TX Data

Note: I have a new computer with Windows 7 and Intel core I5, but did not yet 
install the software to see if this resolves the issue.

Original issue reported on code.google.com by XV1X.Vie...@gmail.com on 31 Oct 2013 at 2:42