search

nobletoll / powersdr-if-stage

Automatically exported from code.google.com/p/powersdr-if-stage
Other
0 stars 0 forks source link

Yaesy FT-736r CAT parms in IF, not working - error on com port ! #230

Open GoogleCodeExporter opened 9 years ago

GoogleCodeExporter commented 9 years ago 
Start the Setup IF
1. Rig type Yaesu
2. The com parms filled in:
Port: COM 3
Baud: 4800
Parity: none
Data: 8
Stop: 2
Thes parms are the main setup parms for the CAT interface of the FT-736.
The only parm who I can not change is the start bit ( must be 1 )

It should be very fine, if the parms for the Yaesu FT-736r will work in the 
application.
I will use the powerSDR/IF version to monitor the second IF at 13.69 Mhz with a 
bandwidth of about 20 KHz.
To make a better reception of the cubesat satellites.

Is an patch about this problem possible ?

Other Rig programs working fine with the CAT interface !

Regards,
Eric, PA2EON

Original issue reported on code.google.com by scdz...@gmail.com on 30 Dec 2013 at 3:59