search

nofeletru / UsbAsp-flash

Program allow you to program flash memory on the protocols spi, I2C, MicroWire. Supports CH341a, CH347, UsbAsp, AVRISP(LUFA), Arduino, FT232H.
MIT License
931 stars 192 forks source link

Can you add W25Q256JVEQ? #43

Closed bananamarcia closed 3 years ago

bananamarcia commented 3 years ago

50be992e-8938-43d7-94ea-7b5f1339d8ac

nofeletru commented 3 years ago

Download new chiplist.xml https://raw.githubusercontent.com/nofeletru/UsbAsp-flash/master/chiplist.xml

bananamarcia commented 3 years ago

There are two W25Q256JVEQ with two diffrent id... can you pls tell me which is mine?

nofeletru commented 3 years ago

There are two W25Q256JVEQ with two diffrent id... can you pls tell me which is mine?

W25Q256JV-QI /IN /JQ 184019h W25Q256JV-IM /JM 187019h it does not matter since it uses same commands

bananamarcia commented 3 years ago

okay, thanks...

bananamarcia commented 3 years ago

WHAT SHOULD I DO? My ch341a programmer doesn't read my bios W25Q256JVEQ...

nofeletru commented 3 years ago

Did you desolder chip? If program do not read chip ID then this some wireing problem.

bananamarcia commented 3 years ago

I didn't desolder the chip. I will try to explain the situation, maybe I was wrong in some steps. I just disconnected the battery and the CMOS from my hp elitebook 830 g5. Then without desolding the BIOS chip I connected it to the programmer with the tweezers provided in the kit, after I installed the programmer drivers. You said it could be a wiring problem, about what, the programmer or the tweezers?

nofeletru commented 3 years ago

It highly recommended to desolder chip. No guarantee that you can program ic on main board without desoldering it.