search

nophead / Mendel90

A RepRap Mendel variant using sheets for the frame instead of rods
http://hydraraptor.blogspot.com/2011/12/mendel90.html
261 stars 248 forks source link

Support non-square print bed. #36

Closed Lenbok closed 10 years ago

Lenbok commented 10 years ago

While you can currently attempt to specify non-square print surfaces using bed_width and bed_depth, the y carriage is always square. This patch separates out Y carriage hole spacing for X and Y directions, allowing proper use of non-square beds, e.g. Makerfarm 8.4" x 12.6" Heat Bed.

Lenbok commented 10 years ago

No longer needed, now master supports non-square bed.