search

nullquant / ComfyUI-BrushNet

ComfyUI BrushNet nodes
Apache License 2.0
384 stars 14 forks source link

报错 #111

Closed 52Hz-p closed 1 week ago

52Hz-p commented 3 weeks ago

RuntimeError: Expected all tensors to be on the same device, but found at least two devices, cpu and cuda:0! (when checking argument for argument mat1 in method wrapper_CUDA_addmm)

nullquant commented 3 weeks ago

Could you please post a full ComfyUI log?

icesun963 commented 2 weeks ago

comfyui_8190.log same error

nullquant commented 1 week ago

I can not produce this error on my side, so I tried to repair it but not sure about result. Update nodes and give it a try. If the error persists post ComfyUI log please.

icesun963 commented 1 week ago

comfyui_8190.log powerpaint work good ,but brushnet still error.

nullquant commented 1 week ago

Log is empty.

icesun963 commented 1 week ago

comfyui_8190.log Sorry, my mistake, I'll upload it again.

nullquant commented 1 week ago

This error was produced in controlnet ComfyUI module. It is not due to BrushNet. What about example workflows with BrushNet, do they work in your setup?

icesun963 commented 1 week ago

I did some tests and found that cn was missing and not working in my environment. It should be some problems caused by the update of comfyui. Thank you very much for your reply.

nullquant commented 1 week ago

You are welcome!