search

nygma2004 / RFID_Wiegand_MQTT

RFID Wiegand MQTT Access
GNU General Public License v3.0
27 stars 8 forks source link

RFID reader not outputting wiegand code? #7

Closed RobbeM1991 closed 2 years ago

RobbeM1991 commented 2 years ago

Hi, I bought the exact same Wiegand reader as yours. But it's not outputting anything on the D0 and D1 lines (don't have a scope to measure though).

Did you have to configure anything on the reader?

Chapter 5 says something about: 1) Access control mode 2) Read head mode (Wiegand 26 output) 3) Reading head mode (Wiegand 34 output) But the translation is not really clear and I'm not sure if I need it. Especially the the reset function is not clear so I'm hesitating to try something...

Thanks!

thehijacker commented 2 years ago

Check here.

https://github.com/nygma2004/RFID_Wiegand_MQTT/issues/1

RobbeM1991 commented 2 years ago

Check here.

1

I've done exactly that. Connect D0 to GND, restart, disconnect when green light is flashing. Then it is just blinking red... But it's working like that! The codes get sent over the D0 and D1 lines!