search

o-devices / bldc-ffb-wheel

DIY FFB Wheel project based on STM32 controller board and BLDC motor
123 stars 26 forks source link

Print settings. #9

Open 86abaile opened 2 years ago

86abaile commented 2 years ago

What did you print the parts in and what settings did you use?

olukelo commented 2 years ago

Hi, I printed them in PA12 SLS(just because I had such opportunity), but those parts do not need high tolerances and strength, so I think any material that you are good in prnting of will be ok.

gwozdziu123 commented 1 year ago

Hello, I use standard PLA with 80% infill.