search

o-gs / dji-firmware-tools

Tools for handling firmwares of DJI products, with focus on quadcopters.
GNU General Public License v3.0
1.51k stars 417 forks source link

Mavic Mini Linear Hall calibration failed #181

Open Agrestbar opened 3 years ago

Agrestbar commented 3 years ago

Screenshot_20201117-011435 Hi there! Just tried to perform the calibration of the Linear Hall sensor but it failed. Do you have any ideas what should i check when it comes to the hardware problems? Which part is responsible for the linear hall sensor calibration?

Denis14071982 commented 3 years ago

Был ответ от "Мефистотелис" по этой проблеме! Но я пока не разобрался! Нужен пример!) "Чтобы это исправить, нам понадобится ответный пакет. Запустите команду с параметром «-vv» и вставьте полный журнал. Он должен содержать ответ в виде шестнадцатеричной строки."

mefistotelis commented 3 years ago

The "Unrecognized response" error has no effect on the actual calibration.

Also, please use English.

Denis14071982 commented 3 years ago

Thanks! That does not affect, I was convinced! But how to remove the message in DJI Fly with code 40011?

MarcoBarba77 commented 3 years ago

hello i have the problem with gimball calibration of my MAVIC MINI .After crush i have put a new cable on the gimball, but i can see only the camera but the gimball dosn't move .Also after calibration , nothink happen , only the JointCoarse move a little be the gimball , but the other command nothing do . If you have some suggestion , please let me know . sorry for my english