search

o-gs / dji-firmware-tools

Tools for handling firmwares of DJI products, with focus on quadcopters.
GNU General Public License v3.0
1.44k stars 403 forks source link

Mavic air always LED Battery ON and dron starts, when insert the battery #347

Open nekropolis opened 1 year ago

nekropolis commented 1 year ago

hi!

Always Battery indicator is displayed, can't switch - LED_DISPLAY: 1=On [LED] LED Display state Does not respond to power button

Сan anyone help? I will provide more information if needed.

      SYS_PRESENT_LOW:  0=Inactive  [PRES]  System present input state low
       DSG_FET_STATUS:  0=Inactive  [DSG]   Discharge FET status
       CHG_FET_STATUS:  0=Inactive  [CHG]   Charge FET Status
      PCHG_FET_STATUS:  0=Inactive  [PCHG]  Precharge FET Status
          FUSE_STATUS:  0=Inactive  [FUSE]  FUSE input status
      TRIP_POINT_INTR:  0=Inactive  [BTPI]  Battery Trip Point Interrupt
        SECURITY_MODE:  2=Unsealed  [SEC]   Security Mode
    SHUTDOWN_LOW_VOLT:  0=Inactive  [SDV]   Shutdown triggered via low pack voltage
        SAFETY_STATUS:  0=Inactive  [SS]    Safety mode status
    PERMANENT_FAILURE:  0=Inactive  [PF]    Permanent Failure mode status
 DISCHARGING_DISABLED:  1=Active    [XDSG]  Discharging Disabled
    CHARGING_DISABLED:  1=Active    [XCHG]  Charging Disabled
           SLEEP_MODE:  0=Inactive  [SLEEP] Sleep mode condition met
       SHUTDOWN_BY_MA:  0=Inactive  [SDM]   Shutdown activated by SMBus command
          LED_DISPLAY:  1=On    [LED]   LED Display state
         AUTH_ONGOING:  1=Active    [AUTH]  Authentication ongoing
   AUTO_CC_OFFS_CALIB:  0=Cal Done  [ACALM] Auto CC offset calibration by SMBus cmd
    RAW_ADC_CC_OUTPUT:  0=Inactive  [CALOC] Raw ADC/CC data calibration output
    RAW_CCOFFS_OUTPUT:  0=Inactive  [CALOO] Raw CC offset data calibration output
     XLOW_SPEED_STATE:  0=Inactive  [XL]    400 kHz transmission SMBus mode
          SLEEP_BY_MA:  0=Inactive  [SLEPM] SLEEP mode activated by SMBus command
     INIT_AFTER_RESET:  0=Inactive  [INIT]  Initialization after full reset
       SMB_CAL_ON_LOW:  0=Not in Cal    [SLCAL] Auto CC calibration when the bus is low
    ADC_MEAS_IN_SLEEP:  0=Inactive  [SLPAD] ADC Measurement in SLEEP mode
     CC_MEAS_IN_SLEEP:  0=Inactive  [SLPCC] Current Check measurement in SLEEP mode
       CELL_BALANCING:  0=Inactive  [CB]    Cell balancing status
   EMERGENCY_SHUTDOWN:  0=Inactive  [EMSHT] Emergency Shutdown

after charging

       DSG_FET_STATUS:  1=Active    [DSG]   Discharge FET status
       CHG_FET_STATUS:  1=Active    [CHG]   Charge FET Status

and if insert the battery into the drone, it starts, but can't fly - battery not installed properly