search

o-gs / dji-firmware-tools

Tools for handling firmwares of DJI products, with focus on quadcopters.
GNU General Public License v3.0
1.44k stars 403 forks source link

LinearHall calibration not working on Mavic Mini #348

Open jla555 opened 1 year ago

jla555 commented 1 year ago

I'm trying to calibrate the gimbal of a friend's Mavic Mini. After it it fell to the ground, the camera points a bit to the left. When I run the JointCoarse calibration command, the gimbal moves around to calibrate, but after that still points to the left. Then, when I run the LinearHall command, nothing happens - the camera does not move at all.

I'm using the following commands:

py comm_og_service_tool.py --port com3 WM160 GimbalCalib JointCoarse

py comm_og_service_tool.py --port com3 WM160 GimbalCalib LinearHall

The drone is on FW v01.00.0600.

Any ideas or suggestions to also get the LinearHall calibration to work? If you need more info, please let me know.

(I don't know much about drones. My friend just asked me to help him, since I have some computer and electronics skills.)

brettwallace commented 8 months ago

I'm running into the same issue with no response to the LinearHall command with my Air 2S. Did you find a solution?

kramer123 commented 8 months ago

I've had success on a few air 2 and air 2s, if the script is correct , it took a few seconds to start moving but linear moved it up and down and I think side to side.

   

Sent: Sunday, November 05, 2023 at 9:27 PM From: "brettwallace" @.> To: "o-gs/dji-firmware-tools" @.> Cc: "Subscribed" @.***> Subject: Re: [o-gs/dji-firmware-tools] LinearHall calibration not working on Mavic Mini (Issue #348)

 

I'm running into the same issue with no response to the LinearHall command with my Air 2S. Did you find a solution?

— Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you are subscribed to this thread.Message ID: @.***>